As you may have seen in our specialty bracket sub-listing, we have brackets to suit our ST3k 20LED 21.5” slim lightbar for the lower grill section of the PX2 Ford Ranger.
Although designed and specified for the PX2, the same brackets are able to be mounted to the PX3 model, with a couple of provisoes...
The PX3 Ranger can be optioned with and without an AEB (autonomous emergency braking) radar, which now places this centrally in the lower grill. (shown below)

The clearance of the light-bar to the upper part of the bumper opening is identical to the PX2 ranger, however, Ford has enlarged the opening on the bottom edge only.
The brackets were originally designed for the PX2, however, they will fit the PX3 rangers without tech pack and also with tech pack, albeit with two separate bars.

Installation is as follows.

The grille will need to be removed as well as the radiator cover to gain the most access to the impact beam. There are 2 clips shown in the above photo.

With the grille now removed, place the brackets into position and dummy fit the light so that you have the correct spacing when drilling. Once you have both brackets in position, best done using a drill that is corded and does not have the additional thickness from the battery pack, drill the holes required for the 2 smaller bracket pieces.
Finally, secure the lights and brackets to the impact beam. For help with wiring, refer to our wiring help center article.
All required components are included in the following kit: